Entering And Resuming From Power Saving Mode - Fujitsu FI-800R Operator's Manual

Entering and Resuming from Power Saving Mode

The scanner enters power saving mode when it is left on without being used for a certain period of time.
Power saving mode keeps the power consumption low when the scanner has not been used for a certain period
of time.
Power saving mode has two types of settings.
● Power Save
If the scanner is left powered on for 15 minutes (factory default setting) or longer without being used, it
automatically enters power saving mode.
When the scanner enters power saving mode, the LED indicator flashes in green.
To resume from power saving mode, perform one of the following:
- Insert a document into the return path opening or load a document in the ADF paper chute (feeder).
- Press the [Scan/Stop] button.
- Scan a document with the image scanning application.
● Auto Shutdown
The scanner is turned off automatically if it is left on without being used for a certain period of time (4 hours
for the factory default setting).
To turn the power back on after the power is turned off automatically, press the [Power] button on the
scanner. For details, refer to
ATTENTION
● If there is a document that remains on the paper path, the scanner may not enter power saving mode.
Remove the documents by referring to
● For some image scanning applications, the scanner may not be turned off even if [Auto Shutdown hours]
is specified.
● If the scanner is automatically turned off while you are using the image scanning application, exit the
application, and then turn the scanner back on.
HINT
The waiting time for entering power saving mode can be changed in the Software Operation Panel.
For details, refer to
How to Turn the Power ON (page
When a Paper Jam Occurs (page
Waiting Time for the Scanner to Enter Power Saving Mode [Power saving] (page
29).
103).
30
Basic Operations
193).