Represent; Incorporating Values In The Standard Display; The Standard Display - Eaton NZM2 Manual

11/04 MN01219002Z-EN

REPRESENT.

Absolute (Y/N)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Represent.
The DMI is factory set to display all currents as relative
values, i.e. as % values of I
correspond to the markings on the NZM. However, absolute
values are also possible in Amps.
Make the selection in the Represent. display menu.
X
The following screen shows Absolute and the setting Y (=
Yes) or N (= No).
Use the cursor buttons to select between Y and N.
X
Confirm the setting with OK.
X

Incorporating values in the Standard display

For example, you can show important parameters, the status
of the digital inputs and the current time in the display.
Select a submenu, e.g. Currents in the Display menu.
X
Use the cursor buttons
X
parameter, e.g. I
Confirm the selection by pressing OK.
X
The value for I
1
following Section "The standard display").

The standard display

In the main menu use cursor buttons
X
Display.
Confirm your selection by pressing OK.
X
h The standard display appears automatically in the LCD
display if buttons on the DMI have remained in a non-
actuated state for 30 seconds or longer. It is only
overwritten by alarm messages from the NZM (a section
"Alarm messages", Page 66).
Data interrogation
. It is therefore factory set to
r
or to select the required
Í Ú
.
1
is incorporated in the Standard display (a
or to select
Í Ú
33