Eaton NZM2 Manual page 175

NZM-XDMI-DPV1
(PROFIBUS-DPV1 Interface for
DMI)
170
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 47: Address location and meaning of the object data
content
Variable access
(example)
DMI_Inputs[1]
DMI_Inputs[2]
DMI_Inputs[3]
DMI_Inputs[4]
DMI_Inputs[5]
DMI_Inputs[6]
h A set bit corresponds to the "ON" state and a bit which is
not set corresponds to the "OFF" state.
h With a parameterized motor-starter function, inputs I1
and I3 indicate the current state of the motor control
(a section "Format of the data inputs", Page 86.
DMI outputs object
This object contains the current states of the outputs Q0 to
Q5 of the DMI.
This object is a read only object. It can be accessed by class 1
and/or a class 2 DPV1 master.
Intended usage
Use this object in order to obtain information concerning the
state of the outputs of the DMI.
h
You can read the state of all outputs of the DMI with this
object, regardless of if they have been parameterized for
"bus access".
Data position
Octet 1
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6 and Bit 7
11/04 MN01219002Z-EN
Meaning
State I0
State I1
State I2
State I3
State I4
State I5
Not used