Batch Key - Xerox 5101 User Manual

8 Special Feature Keys
After the printing of the set, the set can be recalled, the values changed again, and the set
reprinted using the new values. To recall the set, refer to "Store/Recall key" in the "Special
features key" section of this manual for further information.
NOTE: Settings for the last document scanned are not restored when recalling a set. After a set
is recalled, all LED's will be turned off. If a setting is changed after a set is recalled, it will
be applied to all documents in the set.

Batch Key

The Batch feature allows you to improve copy speed by enabling Batch Mode processing of
several documents on the Scan System. When Batch Mode processing is enabled, the Scan
System collects prescan information for just the first document inserted into the Scan System.
Prescan information on subsequent documents in the set is not collected. The subsequent
documents will be scanned using the information collected on the first document. Eliminating the
collection of this information increases overall copy speed.
To enable Batch Mode processing:
1. Press the Batch key. The Batch indicator lamp will begin flashing.
2. Insert the first original into the Scan System. The Scan System scans the original
and the screen shown below is displayed.
INP UT ANOTHER WID TH OR
PRESS ENTER TO ACCEPT
3. Do one of the following:
4. When the last document in the set has been scanned, press the Batch key to disable
batch mode. The Batch indicator lamp is extinguished.
NOTE: When Batch mode is ENABLED, the AUTOCENTER feature is temporarily disabled. Be
careful to manually center each document that is inserted into the Scan System
82
WIDTH FOUND FOR SE T IS XX.X
Width Found for Set is XX.X Screen
Use the numeric keypad to enter the width of the set and press the Enter key to
accept the value.
Press the Enter key to accept the width detected by the Wide Format Copy
System.
The Batch indicator lamp becomes steady and remains so until batch mode is
disabled.
Wide Format Copy System User Guide