Scanner Control - Xerox 5101 User Manual

10 Main Menu
POWER SAVER DELA Y (0 − 4 HR): 3
5. Use the numeric keypad to enter the power saver value. The valid value range is 0
to 4 hours. The factory default is 3 hours.
6. Press the Enter key to confirm the value.
7. Press the Exit key to return to the CONFIGURATION menu screen.

Scanner Control

The SCANNER CONTROL option of the CONFIGURATION menu allows you to set the options
for how the Scan System starts and finishes a scan. It contains the following features:
•
AUTOSCAN - Tells the Scan System either to start the scan automatically when the
document is inserted (ENABLED), or to wait until the Start key is pressed
(DISABLED). ENABLED is the factory default setting.
•
DOCUMENT RETURN - Tells the Scan System, after the scan, either to return the
document to the front of the Scan System (FRONT), or to drop the document from
the rear of the Scan System into the catch tray (REAR). REAR is the factory default
setting.
NOTE: Refer to Controlling the Scan for additional information.
MODE: (PRODUCTIVITY is the default.)
•
MANUAL WIDTH - The user must enter the document width and very carefully center
the document. In this mode the document will be prescanned.
•
AUTOWIDTH - Enables the automatic detection of the width of the document. In this
mode the document will be prescanned.
•
AUTOWIDTH/AUTOCENTER - Enables the automatic centering of the image and
automatic width detection. This selection is the default. In this mode the document
will be prescanned.
•
PRODUCTIVITY - This feature does not use AUTOCENTER, requiring the operator
to manually align the document within the media guidelines on the Feed-in Tray. The
width sensors eliminate the need for a prescan, thereby increasing the overall
throughput of the system resulting in higher productivity. When this feature is used,
the operator must select the media series, ANSI, ARCH, ISO A, ISO B JIS B and
CUSTOM etc. since the number of sensors provided cannot monitor every media
type.
To use the MODE: PRODUCTIVITY: CUSTOM the custom sizes must be entered in
the CUSTOM MEDIA FORMATS (Select the Menu key > CONFIGURATION>COPY
OPTIONS).
To set the Scanner Control features:
1. Press the Menu key. The MAIN MENU screen is displayed.
2. Press the Enter key to select CONFIGURATION. The CONFIGURATION menu
screen is displayed.
110
POWER SAVER
Power Saver Screen
Wide Format Copy System User Guide