Table of Contents
Advertisement
MAINTENANCE
METHOD FOR LUBRICATING REAR AXLE PIVOT PIN
(2 places)
1.
By using a grease pump, pump in grease through the
grease fittings shown by arrows.
Pump in grease until new grease comes out through the
gap on either the right or left (or top or bottom) of the lubri-
cated portion.
2.
After greasing, wipe off any old grease that is pushed out.
METHOD FOR CHECKING OIL LEVEL IN HYDRAULIC TANK, ADDING OIL
•
Immediately after the engine is stopped, its parts and oil are still very hot and may cause burn in-
jury. Wait for the temperature to go down, and then start the work.
•
When removing the oil filler cap, the oil may spurt out. Turn it slowly to release the internal pres-
sure, then remove it carefully.
k
k
WARNING
MAINTENANCE PROCEDURE
4-47
Advertisement
Chapters
Table of Contents
