Komatsu WA200-8 Operation & Maintenance Manual page 272

TRANSPORTATION
NOTICE
This method of lifting applies to the standard specification machine.
The method of lifting differs depending on the attachments and options installed.
For the procedure for the machine with other than standard specification, consult your Komatsu distrib-
utor.
For the weight, see "SPECIFICATIONS".
Procedure for lifting machine
Lifting work is allowed for only machines having lifting marks.
Before starting the lifting work, check that the machine has the
lifting marks on 4 places shown in the figure.
Before starting the lifting work, place the machine on a level ground and perform the following.
1.
Start the engine.
2.
Set the machine horizontally and set the work equipment
in the travel posture.
(A): 30 cm
3.
Check that the multifunction mono-lever is in "HOLD" posi-
tion.
4.
Press the work equipment lock switch (1) and lock the
work equipment (the pilot lamp in the switch is lit).
5.
Stop the engine.
6.
Check the safety around the operator's seat, set the frame
lock bar to LOCK position (L) in order to prevent the front
frame and rear frame from being articulated.
3-208
OPERATION