Operating Instructions; Rate Settings - The Handy THS50 Operator's Manual And Parts List

OPERATION
Before filling the hopper, familiarise yourself with the operation of the spreader.
• Using the Rate Setting Chart on Pages 11 and 12, obtain the correct setting for the
material to be used.
• Move the Stop bolt on the rate gauge to the correct setting.
• Whilst pushing the spreader forward, pull the control lever back to the Stop bolt.
• To stop, push the lever forward to close the feed gate at the bottom of the hopper.
• After use empty any remaining material from the hopper.
• Thoroughly wash the spreader and allow to dry before storing. Oiling is NOT necessary.
• Remove the agitator when using rock salt to prevent gearbox damage.
• If the spreader does not spread evenly, ensure that the FRONT of the gearbox points
towards the front of the spreader. The impeller must turn clockwise. Fertiliser which is
stuck on the impeller blades will cause uneven spreading.
• The spreader is designed to be pushed at 3 miles per hour - brisk walking pace. The
rate of walking will affect the spread pattern and flow rate.
• The gears are permanently lubricated at the factory and do not need re-oiling. Do NOT
open the gearbox as dirt may get in.
Page 9