Table of Contents
Advertisement
Hardware and Installation Manual
Carefully align the edges of the card with the top and bottom card guides. Then, push the card
along the length of the card guides until the rear connectors on the card engage the mating
connectors on the target shelf backplane.
5. Push in the top and bottom inject/eject clamps (see
Figure 12: E5-APP-B Card Inject Levers
This locks the card in place and ensures a strong connection with the pins on the target shelf
backplane.
6. Slide the E5-APP-B H/S switch (4) down to the LOCKED position (see
Inject Hardware Switch,
Note: When the Ejector switch goes from UNLOCKED to LOCKED, the E5-APP-B Eject Status
LED blinks red as the E5-APP-B card goes online.
910-6535-001 Revision D, February 2014
LOCKED).
Installing and Removing E5-APP-B Cards
Figure 12: E5-APP-B Card Inject
Figure 13: E5-APP-B Card
Levers).
43
Advertisement
Table of Contents
Need help?
Do you have a question about the EAGLE Application B Card and is the answer not in the manual?
Questions and answers