Mitsubishi Electric Melservo MR-J5 G Series User Manual page 13

Model: MR-J5-
*2
Close mounting 3-phase power supply input
1-phase power supply input
Mass [kg]
*1 This value is applicable when all I/O signals are used. Reducing the number of I/O points decreases the current capacity.
*2 If closely mounting the servo amplifiers, operate them at an ambient temperature of 0 ˚C to 45 ˚C or at 75 % or less of the effective load
ratio.
*3 This current value is applicable when a 3-phase power supply is used.
*4 If using 1-phase power supply in combination with the servo motor of 750 W or higher, operate the servo amplifier at 75 % or less of the
effective load ratio.
*5 The command communication cycle depends on the controller specifications and the number of the connected axes.
*6 This does not apply to connectors.
*7 The communication cycles of 31.25 μs and 62.5 μs can be used by servo amplifiers with firmware version A6 or later.
10G 20G 40G 60G
Possible
Possible
0.8 1.0
70G 100G 200G 350G

Impossible
1.4 2.2
1 SPECIFICATIONS
1.4 Servo amplifier standard specifications
500G 700G
1
3.7 6.2
11