7-Segment Led - Mitsubishi Electric Melservo MR-J5 G Series User Manual

Test operation select switch (SW3-1)
Turning "ON (up)" the test operation select switch enables the test operation mode. In the test operation mode, functions such
as JOG operation, positioning operation, and machine analyzer are available using MR Configurator2.
Page 53 Test operation
Disabling control axis switches (SW3-2, SW3-3, and SW3-4)
Turning "ON (up)" the disabling control axis switch disables the corresponding servo motor. The servo motor will become in
the disabled-axis state and will not be recognized by the controller.
Rotary switches (SW1/SW2)
The IP address can be set with the rotary switches (SW1/SW2) of the servo amplifier. SW1 indicates an upper digit and SW2
indicates a lower digit of a hexadecimal. The rotary switches are set to 01h when shipped from the factory.
To apply the settings of the rotary switches, set "0" (the rotary switch is used.) in [Pr. NPA01 IP address setting]. To set the IP
address without using the rotary switches, set them to 0 and use an engineering tool.
For how to set IP addresses, refer to "IP address setting function" in the following manual.
MR-J5-G/MR-J5W-G User's Manual (Communication Function)

7-segment LED

The network connection status, servo status, and alarm/warning occurrence statuses can be checked on the 7 segment LED
display.
Display sequence
The following shows the display sequence of the 7-segment LED display after power-on. Once a system check is complete
and the servo amplifier is started, the network connection status will be displayed.
Servo amplifier power on
Controller power on
(Network communication start)
*1
Controller power off
*1 The segment of the last 2 digits shows the IP address.
Page 40 When the network is connected
Controller not connected
Controller not connected
(Initialization communication in progress)
Controller is connected
3.2 Switch setting and display of the servo amplifier
3
3 STRUCTURE
39