Starting The Bar Feed System; Description; Settings Related To Installation; End Of Bar Position Top-Cut Position - LNS QUICK LOAD SERVO S3 Startup Manual

2
1.
1.1
All handling, optional accessories and settings required by the bar feed system to carry out
a specific job are part of the set-up.
A few simple operations are necessary to prepare the device to handle another range of
diameters.
The set-up procedures have been divided into 4 categories:

Settings related to installation :

C
C
Settings related to bar stock and machined parts :
C
C
C
C
Mechanical settings and optional accessories :
C
C
C
C
Lathe set-up :
C
C
The procedures to be followed are explained in this chapter and will be presented as concrete
examples, whenever possible.
QUICK LOAD SERVO III

STARTING THE BAR FEED SYSTEM

Please read the safety measures explained at the beginning of the Instruction
manual before handling the following equipment.

Description

End of bar position
Top-cut position
Example 1: Set-up for round bars
Example 2: Set-up for hexagonal bars
Example 3: Set-up for square bars
Example 4: Set-up for "others" bars
Replacement of the feeding pusher
Slope of the magazine table
Settings of the loading fingers
Settings of the loading table
Spindle reduction tubes
Optional accessories for profiled bars
START UP MANUAL