Table 6: Alarm Input Monitoring (Dip Switch S4) - Oracle Tekelec 1200 Installation Manual

Installation
DIP Switch
Position 1 - 8
8
Note: LED for the associated supply input and breaker when enabled shall illuminate either:
• GREEN when -48VDC is connected
• RED when -48VDC is not connected
Note: When position 8 is set ON, DIP switch settings 1-6 are ignored with 7 active. For example,
if alarm inputs are enabled for PAN and PBN, but disabled for PCN, then the BUS input supply
monitoring LEDs are enabled for Group A (inputs 1- 4) and Group B (inputs 5-8), but disabled for
Group C (inputs 9-12).
5. Use

Table 6: Alarm Input Monitoring (DIP Switch S4)

specify monitoring of alarm cable inputs on a group (A, B, and/or C) basis.
Note: Factory settings are S4:6 is OFF, all other positions for S2, S3, and S4 are ON.
Table 6: Alarm Input Monitoring (DIP Switch S4)
DIP Switch
Position 1 - 6
1
2
3
4
910-5681-001 Revision E, February 2014
Group Breaker and LED
Position
------ ------
Alarm Input
PAN
PBN
PCN
------
Setting
ON
OFF
to set DIP switch S4 positions 1 through 4 to
Setting Description
Alarm Input Enabled
ON
and Monitored.
Alarm Input Disabled
OFF
and Not Monitored.
Alarm Input Enabled
ON
and Monitored.
Alarm Input Disabled
OFF
and Not Monitored.
Alarm Input Enabled
ON
and Monitored.
Alarm Input Disabled
OFF
and Not Monitored.
Use S4:1-S4:3 settings
ON for alarm input
monitoring.
Cabinet Installation
Description
Overrides DIP
switch positions
1-6 settings. See
S4:1-S4:4 settings.
Enable DIP switch
settings 1-6.
70