Daewoo B20S-2 Disassembly/Assembly page 54

Seal
Gland
Bushing
(with seals)
IDCD294S
16. Install seal gland bushing over the spool end with
a twisting motion. Tap the bushing in place with a
rubber hammer. Make sure the bushing is flush
against the bearing race.
Screwdriver
Dust Seal
Retaining
Ring
Seal Gland
Bushing
Quad Ring
Seal
Seal
IDCD295S
17. Install retaining ring in housing. After installing
ring, tap on ring end or pry with screwdriver
around entire circumference of ring to properly
seat ring in groove.
Vehicle Systems
Retaining
Ring
IDCD296S
18. Clamp housing in vise. Clamp lightly on edges of
mounting area. Do not over tighten jaws.
NOTE: Check to insure that the spool and sleeve are
flush or slightly below the 14 hole surface of the
housing.
ATTENTION: Clean the upper surface of the housing
by wiping with the palm of clean hand. Clean each of
the flat surfaces of the meter section parts in a simi-
lar way when ready for reassembly. Do not use cloth
of paper to clean surfaces.
IDCD297S
19. Install 73.5 mm [2.89 in.] ID seal in housing.
20. Install spacer plate. Align bolt holes in spacer
plate with tapped holes in housing.
53 Disassembly & Assembly