Daewoo B20S-2 Disassembly/Assembly page 53

Pin
IDCD292S
11. Position the spool and sleeve assembly so that
the splined end of the spool enters the 14 hole
end of housing first.
ATTENTION: Be extremely careful that the parts do
not tilt out of position while inserting. Push parts gen-
tly into place with slight rotating action, keep pin
nearly horizontal. Bring the spool assembly entirely
within the housing bore until the parts are flush at the
meter end or 14 hole end of housing.
Do not pull the spool assembly beyond this point to
prevent the cross pin from dropping into the dis-
charge groove of the housing. With the spool assem-
bly in this flush position, check for free rotation within
the housing by turning with light finger tip force at the
splined end.
Vehicle Systems
Needle
Thrust
Bearing
Seal
IDCD293S
12. Place housing on clean lint free cloth. Install 47,5
mm [1.86 in.] ID seal in housing.
13. Install 2 bearing reces and the needle thrust
bearing in the order shown.
14. Install 25 mm [1 in.] ID dust seal in seal gland
bushing, flat or smooth side must face down
towards bushing.
15. Install the quad ring seal in seal gland bushing.
Smooth seal in place with your finger. Do not use
any seal that falls freely into pocket of bushing.
52
Bearing
Race (2)
Disassembly & Assembly