IDCD287S
18. Push spool partially from control end of sleeve,
then remove 4 centering springs from spool
carefully by hand.
19. Push spool back through and out of sleeve.
Rotate spool slowly when removing from sleeve.
20. Remove seal from housing.
Vehicle Systems
Seal
9,3mm
[.36in.] ID
Set Screw
IDCD288S
21. Remove set screw from housing.
22. Screw a #10-24 machine screw into end of check
ball seat. Then by pulling on screw, with a pliers,
lift seat out of housing.
23. Remove 2 seals from check valve seat.
24. Tip housing to remove check ball and check ball
retainer.
49
Check
Check
Ball
Ball
Check
Seat 7.7mm
Ball
[.30 in.] ID
Retainer
Disassembly & Assembly