IDCD253P
9. Remove seal (11) from the spacer.
IDCD425P
10. Remove O-ring seal (12) and back-up ring (13)
from the head.
IDCD426P
11. Remove seals (14), (15), and (16) from the head.
NOTE: Use the following steps to assemble the tilt
cylinder.
Vehicle Systems
11
IDCD426P
12. Install seal (14) in the head. Position the lip of
13. Install seal (15).
12
14. Install seal (16) in the cylinder head. Position the
13
IDCD425P
NOTE: The curved side of back up ring (13) should
14
contact O-ring seal (12).
15. Install O-ring seal (12) and back-up ring (13).
15
16
37
the seal toward the inside of the head.
lip of seal (16) toward the outside of the cylinder
head.
Make sure the curved side of back-up ring (13) is
in contact with O-ring seal (12).
Disassembly & Assembly
14
15
16
12
13