Side Panel - Owon TAO 3000 Series Quick Manual

zooming mode.
6. Trigger button: Accesses to trigger system setting. When the button light is on, the A
knob is used to adjust trigger level of current channel.
7. The B knob:
When one of the CH1 – CH2 buttons is lighted, this knob is used to adjust the voltage
scale of current channel.
When HOR button is lighted, this knob is used to adjust time base.
8. Copy button: You can save the waveform by just pushing this button in any user
interface. The source wave and the storage location are set in the Save menu when the
Type is Wave (
9. Default button: Press this button, a prompt will show, press again to execute the
factory settings.
10. Autoset button: Quick way to apply a set of pre-set functions to the incoming signal,
and display the best possible viewing waveform of the signal.
11. Single button: Set the trigger mode as single directly.
12. Run/Stop button: Enable or disable sampling on input signals.
13. DMM button : Quickly On/Off DMM and measure parameter switch button.
Select: Switch between AC and DC when measuring voltage or current; and switch
resistance, continuity, diode, and capacitance measurement when selecting other.

Side Panel

1. Probe Compensation: Measurement signal (5V/1kHz) output.
2. Trig Out or Pass/Fail output connector: Trigger signal output or Pass/Fail output. The
output type can be set on the menu (
3. USB Device port: It is used to transfer data when external USB equipment connects to
3.Quick Start
→ Save).
Figure 3-2 Rear Panel
→ Utility → Function → Output → Output).
5
1
2
3
4
5
6