Table of Contents
Advertisement
(3) Port
setting
"Communications" on the menu bar, choose "Ports-Settings", in the setting dialog,
choose "Connect using" as "USB". After connect successfully, the connection
information in the bottom right corner of the software will turn green.
Figure 4-1 Connect with PC through USB port
Using LAN Port
Connect directly
(1) Connection. Plug in the LAN cable to the LAN port in the right panel of the
oscilloscope; plug the other end into the LAN interface of the computer.
(2) Set the network parameters of the computer. Since the oscilloscope can not
support obtaining an IP address automatically, you should assign a static IP address.
Here we set the IP address to 192.168.1.71.
4.Communication with PC
of
the
software:
Run
the
Oscilloscope
21
software;
click
Advertisement
Table of Contents
