Unpacking Your Board - Rastergraf VFX-M User Manual

Rastergraf

2.2 Unpacking Your Board

When you unpack your board, inspect the contents to see if any damage
occurred in shipping. If there has been physical damage, file a claim with
the carrier at once and contact Rastergraf for information regarding repair
or replacement. Do not attempt to use damaged equipment.
Caution
Be careful not to remove the board from its antistatic bag until you are
ready to install it. It is preferable to wear a grounded wrist strap whenever
handling computer boards.
Some operating systems require that you reboot your system after
installing a device driver, because only after the reboot will your system
utilize the driver and recognize the board. If yours is such an operating
system, you might like to install your Rastergraf software before
installing the board since you will have to shut down the computer to
install the board anyway. If you want to install the software before
shutting down the computer, proceed to the correct part of the relevant
software manual and return to this chapter afterwards.
2-2 Installing Your Rastergraf Graphics Board
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com