Table of Contents
Advertisement
Performance Verification
TSG1001 generator rear panel
Figure 4-6: External reference test initial hookup
4-20
Connect the 15-pin, D-type ground closure to the REMOTE connector on the
rear panel. See Figure 4–1 for the switch ID symbols: SWxx, on the ground
closure.
Parallel signal cable
PSC1125
converter
rear panel
Parallel signal cable
Initial Setups.
H TSG1001:
FORMAT:
SWEEP:
. . . . . . . . . . . . . . . . .
H
The Waveform Monitor:
INPUT:
. . . . . . . . . . . . . . . . . .
1. Open all dip switches on the ground closure.
2. Close SW15 and confirm:
H The INPUT B LED lights.
3. Open SW15.
H The INPUT A LED lights.
4. Close SW15.
H The INPUT B LED lights.
5. Close SW11.
H The display changes to STATUS.
75 W BNC cable
. . . . . . . . . . . . . . . .
SMPTE 274M 60Hz (for Option 0A)
SMPTE 296M (for Option 0B)
100 %
CH A
WFM 1125 Option 0A/0B/0C/0D Service Manual
WFM1125 waveform
monitor rear panel
D type ground closure
Advertisement
Table of Contents
