Test Mode - Sony PCM-D100 Service Manual

PCM-D100
1. SETTING THE TEST MODE
Note: Test mode is impossible when battery voltage is not enough. Do
work using the battery with suffi cient battery level.
Setting method:
1. Equip this unit with battery.
2. Slide the [POWER] switch in the direction of "ON" until the
window display appears.
3. While pressing the [F1] and [T-MARK] keys, slide the
[HOLD] switch in the direction of "ON" or "OFF" (Either
"ON" or "OFF" is OK).
F1
T-MARK
4. While pressing the [F1] and [T-MARK] keys, slide the [HOLD]
switch in the direction opposite to that specifi ed in step 3.
5. While pressing the [F1] and [T-MARK] keys, slide the [HOLD]
switch in the direction opposite to that specifi ed in step 4.
6. The test mode menu is displayed, and enter the test mode. Re-
lease the [F1] and [T-MARK] keys.
(Displayed characters/values in the following fi gure are ex-
ample)
LCD Display
<Version>
<Sleep>
<Deep Sleep>
<Off Deep Sleep>
<Power Down>
/
R
2. RELEASING THE TEST MODE
Remove battery.
22
SECTION 3

TEST MODE

HOLD
B
/ [ ENT ]
r
3. CONFIGURATION OF THE TEST MODE
After turn on the power, stop or sleep condition.
While pressing the [F1] and [T-MARK] keys,
slide the [HOLD] switch ON or OFF
(Either ON or OFF is OK).
Slide the [HOLD] switch.
Slide the [HOLD] switch.
Initial state of test mode
Release the [F1] and [T-MARK] keys.
Version
Sleep
Deep Sleep
[ ] key
v
Off Deep Sleep
J
Power Down
LCD Offset
LCD/Led/Light
Log Output
SIN
j
Menu Init
Factory Ship
[ ] key
Sircs Check
V
Keychk+Factory Ship
Version
Remove battery.
End of test mode.
START
Determine
using
[ ]
N
key
k
K
Return using
[ STOP]
x
key