Table of Contents
Advertisement
Using the Menu
DIAG/CAL Menu
2-14
To quit the menu mode, press the INTEN/MENU button again.
For example, turn the GAMUT on by stepping through the menus as follows:
1. Press and hold the INTEN/MENU button to display the Configure menu.
2. Turn the SELECT knob until GAMUT highlights.
3. Push the SELECT button to ON.
4. Push the INTEN/MENU button again to turn off the menu readout without
losing your selections.
For additional information on this menu, refer to the WFM1125 Option 0A/0B/0C
User Manual.
There are following three ways to enter into the DIAG/CAL mode:
H Turn on the Power switch on the rear panel while holding down the
STANDBY button on the front panel.
H Press the INTEN/MENU button while holding down the 5-th bezel button,
and then press the EXECUTE bezel button when the DIAG/CAL menu
appears.
H Turn on the Power switch on the rear panel when the firmwares have not
been downloaded yet to the internal modules.
NOTE. If you enter into the DIAG/CAL mode through the first or third ways, the
waveform monitor is not configured correctly. So, the I/O test in the MEMORY
test will report a FAIL even if the H/W is correct.
When you enter into the DIAG/CAL mode, the DIAG/CAL menu appears at the
far right of the screen (VGA monitor).
WFM 1125 Option 0A/0B/0C/0D Service Manual
Advertisement
Table of Contents
