Table of Contents
Advertisement
Mechanical Parts List
Using the Replaceable Parts List
Parts List Column Descriptions
Column
Column Name
1
Figure & Index Number
2
Tektronix Part Number
3 and 4
Serial Number
5
Qty
6
Name & Description
7
Mfr. Code
8
Mfr. Part Number
Abbreviations
Mfr. Code to Manufacturer
Cross Index
10-2
This section contains a list of the mechanical and/or electrical components that
are replaceable for the waveform monitor. Use this list to identify and order
replacement parts. The following table describes each column in the parts list.
Description
Items in this section are referenced by component number.
Use this part number when ordering replacement parts from Tektronix.
Column three indicates the serial number at which the part was first effective. Column four
indicates the serial number at which the part was discontinued. No entries indicates the part is
good for all serial numbers.
This indicates the quantity of parts used.
An item name is separated from the description by a colon (:). Because of space limitations, an
item name may sometimes appear as incomplete. Use the U.S. Federal Catalog handbook H6-1
for further item name identification.
This indicates the code of the actual manufacturer of the part. (Code to name and address cross
reference is located after this page.)
This indicates the actual manufacturer's or vendor's part number.
Abbreviations conform to American National Standard ANSI Y1.1–1972.
The following table cross indexes codes, names, and addresses of manufacturers
or vendors of components listed in the parts list.
WFM 1125 Option 0A/0B/0C/0D Service Manual
Advertisement
Table of Contents
