Table of Contents
Advertisement
Performance Verification
Performance Tests
Preparations
4-4
The performance test for thewaveform monitor must be performed in the
following order.
H Frequency response
H Low pass filter
H Front panel controls
H Format modes (option 0D only)
H Analog output
H Audio output
H External reference
H Remote functions
H MONITOR out
H VGA output
NOTE. When you do the performance procedures in this section after the A40
CPU and/or A20 Main board have/has been replaced, you must download the
firmware data to those modules first. Refer to Firmware Updates on page 6–9 for
the firmware updating procedures.
To perform tests, download the signal set data: multi.dnl supplied with the
floppy disk to the TSG1001 in advance.
Downloading to the TSG1001.
To load the signal set data into the TSG1001, you should install the SDP1000
communication utility: COM1000 into a PC. The procedures described below
supposes that the necessary utility is already stored in the directory sdp1000.
NOTE. For the details on installation the COM1000, the SDP1000 communica-
tion utility, and downloading the signal set data to the TSG1001, refer to the
manuals supplied with the TSG1001 and SDP1000.
WFM 1125 Option 0A/0B/0C/0D Service Manual
Advertisement
Table of Contents
