Adjustment Procedures
R166
R172
Front
Analog Output
Adjustment
5-6
DL200
Figure 5-4: A10 input board view
WARNING. To avoid serious injury, do not touch exposed connections or
components when operating the instrument with the protective enclosure
removed. Dangerous potentials exist at several points within the waveform
monitor.
Connections.
Connect ANALOG OUT Y connector on the waveform monitor rear panel to the
oscilloscope CH1 input using the 75 W BNC cable and the BNC T connector.
Connect ANALOG OUT P
oscilloscope CH2 input using the other 75 W BNC cable and the other BNC T
connector.
Terminate the other end of the BNC T connectors with the 75 W terminators.
R502
DL210
connector on the waveform monitor rear panel to the
b
WFM 1125 Option 0A/0B/0C/0D Service Manual
R522
R542