Figure 4-2: Performance Test Initial Hookup - Sony Tektronix WFM 1125 Service Manual

Performance Verification
TSG1001 generator rear panel

Figure 4-2: Performance test initial hookup

4-6
Parallel signal cable
PSC1125
converter
rear panel
Parallel signal cable
Initial Setups.
H TSG1001:
FORMAT:
SWEEP: . . . . . . . . . . . . . . . . .
For Option 0C and Option 0D, perform the following procedure using
the format setting for Option 0A and Option 0B respectively.
H
The Waveform Monitor:
INPUT: . . . . . . . . . . . . . . . . . .
Procedure.
1. Press and hold the INTEN/MENU button and select FACTORY :
EXECUTE ! OK.
2. Press the DISPLAY : CH 1 button and GAIN : ON button, and then
bezel button align the sweep waveform with the graticule.
3. Confirm that the amplitude of the sweep waveform is in the range from
696.5 to 703.5 mV and that the accuracy falls within the " 0.5 %.
4. Press 1 bezel button.
5. Press the DISPLAY : CH 2 button and
of the sweep waveform with the graticule.
6. Confirm that the amplitude of the sweep waveform is in the range from
695.1 to 704.9 mV and that the accuracy falls within the " 0.7 %.
7. Press 1 bezel button.
75 W BNC cable
. . . . . . . . . . . . . . . . SMPTE 274M 60Hz (for Option 0A)
SMPTE 296M (for Option 0B)
100 %
CH A
WFM 1125 Option 0A/0B/0C/0D Service Manual
WFM1125 waveform
monitor rear panel
10 bezel button align the marker
10