Numbering Extensions And C.o. Lines - Samsung OfficeServ 7200 Technical Manual

Table of Contents
Home Page
OfficeServ 7200 INSTALLATION
TECHNICAL MANUAL PART 8 SEPTEMBER 2005

8.4 NUMBERING EXTENSIONS AND C.O. LINES

Once the OfficeServ 7200 system is booted, the MCP/LCP board verifies the boards
mounted on each slot and saves this information as the default configuration of the
system.
According to the setting of the S3 switch (SW6, SW7, SW8) of the MCP/LCP board, the
OfficeServ 7200 system assigns 3 or 4 digits to C.O. lines, extensions, and extension
groups. Refer to Section 3. Installing and Replacing Boards of this manual for details
on setting the S3 switch.
C.O. line numbers from 701 or 7001 are sequentially assigned to the C.O. line board
installed on Slot 1 of the main cabinet, and following numbers are continuously
assigned to the next C.O. line board of the next slot. However, only the numbers from
701 to 799 are assigned when using 3 digits. For example, if an 8TRK board is
mounted on Slot 1 and an 8TRK board is mounted on Slot2, 701 is assigned to the
C1/S1/P1 port and 712 is assigned to the C1/S2/P4 port.(Twelfth C.O. line is assigned
to the fourth port of the second slot of the first cabinet.)
Extension numbers from 201 or 2001 are sequentially assigned to the extension board
mounted on Slot 1 of the basic cabinet, and following numbers are continuously
assigned to the next extension board of the next slot. This numbering process
continues until the extension numbers are assigned to all extensions. However, only
the numbers from 201 to 349 are assigned when using 3 digits.
The first port of the first 8DLI or 16DLI board is assigned to the attendant group as
default. All C.O. lines ring this attendant extension unless the default value is changed.
Thus, a phone with an LCD panel should be connected to the last port of the first 8DLI
board.
500-539 or 5001-5039 is assigned to an extension group.
The numbers of C.O. lines, extensions, or extension groups can be changed using the
MMC 724 program.
8.3