Flexible Numbering - Samsung NX-828 Technical Manual

NX-828
HYBRID KEY SYSTEM
See: MMC 53 Trunk Wide Timers
(Default time for FLASH PBX: 600 msec)

Flexible Numbering

System programming allows stations to have 2- or 3-digit station numbers which may be changed
by programming. These will affect the trunk numbers and other feature IDs.
See: MMC 70 Dial Numbering Plan
Flexible Ringing
Incoming outside calls can be assigned to ring a station or a station group. The system provides
separate ringing locations for all trunks in both the DAY and the NIGHT modes.
See: MMC 43 Assign Trunk Ring
Hot/Warm Line
Stations can be programmed to call a pre-defined station, station group, outside line, trunk group
or speed dial number whenever the station goes off-hook. A hot line delay time of 1-9 seconds
can be programmed to allow sufficient time to make a different call.
See: MMC 25 Hot/Warm Line
In Group / Out Of Group
Individuals assigned to a station hunt group may temporarily remove their telephones from the
group by pressing the IOG button. Stations out of a group will not receive calls to that group but
will continue to receive calls to their individual extension numbers. When desired, the user may put
him/herself back into the group by pressing the button again. Users who do not have this button
can dial the access code.
See: MMC 70 Dial Numbering Plan (Default Code for In/Out of Group IOG: 53)
MMC 71 System Key Programming
MMC 72 Station Key Programming
Incoming Call Distribution
Incoming calls can be assigned to ring a distributed station hunt group. This will allow all members
of the group to share the call load.
See: MMC 35 Station Group
MMC 43 Trunk Ring
Incoming / Outgoing Service
Outside lines are available for incoming or outgoing service. Programming allows any outside line
to be used for incoming calls only, outgoing calls only or both-service.
(Default time for NEW CALL: 2000 msec)
3 - 8
FEATURES