OfficeServ 7200
TECHNICAL MANUAL
PART 3. INSTALLING AND REPLACING
BOARDS
This section describes how to install and replace various boards of the OfficeServ 7200
system.
3.1 CABINET CONFIGURATION
The main and expansion cabinets of the OfficeServ 7200 system have six slots each.
The front panel
of an expansion
cabinet
The front
panel of a
main cabinet
Following boards are installed in the slots according to the configuration of the OfficeServ
7200.
Cabinet
Expansion Cabinet
Main Cabinet
Slot 0
Slot 1
Slot 3
Slot 4
Slot 0
Slot 1
Slot 3
Slot 4
Figure 3.1 Front Panel Configuration
Table 3.1 Applicable Boards per Slot
Slot
Slot 0
For LCP ONLY
Slot 1
All boards EXCEPT MCP , LCP , TEPRI and LIM
Slot 2
All boards EXCEPT MCP , LCP , TEPRI and WIM
Slot 3
All boards EXCEPT MCP , LCP and WIM
Slot 4, 5
All boards EXCEPT MCP , LCP , TEPRI and WIM
Slot 0
For MCP ONLY
Slot 1
All boards EXCEPT MCP , LCP , TEPRI and LIM
Slot 2
All boards EXCEPT MCP , LCP , TEPRI and WIM
Slot 3, 4, 5
All boards EXCEPT MCP , LCP and WIM
3.1
Home Page
INSTALLATION
PART 3 SEPTEMBER 2005
Slot 2
Slot 5
Slot 2
Slot 5
Applicable Boards
Table of Contents