Samsung OfficeServ 7200 Technical Manual page 75

Hide thumbs Also See for OfficeServ 7200:

Table of Contents

OfficeServ 7200

TECHNICAL MANUAL

KDB-SLI

This daughterboard can be installed only in the DCS 12 or DCS 24 button keyset.

Before performing this procedure, unplug the line cord from the keyset and remove the

base wedge. Place the keyset face down on a soft surface and remove the four base

retaining screws

(see Figure

keyset aside. Attach the KDb-SLI to the keyset base with the six screws that are

supplied

(see Figure 7.17).

the access hole in the base

and plug the ribbon cable into the socket on the keyset PCB

making sure no damage occurs to the keyset PCB. Reattach the base to the keyset

and test to ensure normal keyset operation.

RETAINING SCREWS

Figure 7.13 Keyset Base

7.13). Separate the base from the keyset and place the

Take care to ensure that the modular socket shows through

(see Figure 7.15).

Invert the base assembly over the keyset

7.10

Table of Contents

Home Page

INSTALLATION

PART 7 SEPTEMBER 2005

(see Figure 7.16)

while

Table of Contents