Riello ALU PRO power Series Instructions For The Installer And The Technical Assistance Centre page 48

When there is a remote storage cylinder (accessory),
after connecting the storage cylinder to the electri-
cal panel and having set the manufacturer parameter
"559=1" (see section "Manufacturer level"):
w
- Press the button
To change the domestic hot water setpoint use the
+
buttons " " and "
To exit press the button
The setting will be stored in memory.
When there is a remote storage cylinder with a thermo-
stat set the manufacturer parameter "559" (see section
"Manufacturer level"):
- con 559=0 boiler only with heating
- con 559=1 storage cylinder probe
- con 559=2 storage cylinder thermostat
- If an outdoor temperature sensor is installed, set install-
er parameter "532 heating curve slope" as instructed in
the section "Setting operating parameters".
If any boiler ignition faults or boiler operating errors are
detected, the display shows the type of error.
There are two types of errors:
- PERMANENT errors are those that can only be deacti-
vated by pressing the
- TEMPORARY errors are those that are deactivated
when the cause of the error disappears (see Error Table
on page 60).
48
TECHNICAL ASSISTANCE CENTRE
.
-
".
w
.
Reset
button.