Configuration Jumpers - Epson S5U13L01P00C100 User Manual

3.3 Configuration Jumpers

The S5U13L01P00C100 evaluation board includes the following 2-pin, 3-pin, 5-pin and 8-pin jumper blocks which
control the functions described in Table 3-3: "2-Pin Jumper Settings", Table 3-4: "3-Pin Jumper Settings", Table
3-5: "5-Pin Jumper Settings" and Table 3-6: "8-PinJumper Setting". For jumper locations on the evaluation board,
see Figure 3-1: "Configuration Switch and Jumper Locations (Red)" on page 10.
Jumper
JP101 Connect COREVDD Power Supply
NOTE
JP102 Connect IOVDD Power Supply to S5U13U00P00C100
JP104 Connect PLLVDD Power Supply
= suggested settings
Note
For normal S5U13L01P00C100 operation, JP102 should be in Position 1-2. Also, when using the
S5U13L01P00C100 with the S5U13U00P00C100, JP102 should be in Position 1-2 (JP1 on the
S5U13U00P00C100 must be in Position 1-2). For IOVDD current measurement, JP102 should be removed.
Jumper Position 1-2
JP105 WR# is from P1 and CN3
JP106 DB0 is from P1 and CN3
JP107 DB1 is from P1 and CN3
= suggested settings
Jumper
Position 1-2
JP108
Position 3-4
= suggested settings
S5U13L01P00C100 Evaluation Board
Rev. 1.3
Table 3-3: 2-Pin Jumper Settings
Position 1-2
Table 3-4: 3-Pin Jumper Settings
WR# is from P2
DB0 is from P2
DB1 is from P2
Table 3-5: 5-Pin Jumper Settings
Position
Position 2-3
Position 4-5
Seiko Epson Corporation
Installation and Configuration
No Jumper (Open)
Connect a current meter for power measurement
No IOVDD Power Supply to S5U13U00P00C100
Connect a current meter for power measurement
Position 2-3
WR# is not connected
DB0 is not connected
DB1 is not connected
Position 1-2: AB0 is AB0 (only for Direct 8bit mode)
Position 2-3: AB0 is TE
Position 3-4: DB8 is TE (only for Direct 8bit mode)
Position 4-5: DB8 is DB8
Off
Function
9