The 2-position DIP switch (SW2) is used to configure for production test only. For normal use this switch state
should be set to "ON".
S5U13709P00C100
SW2-[2:1]
Configuration
SW2-[1]
SW2-[2]
= default setting
3.2
3.2 Configuration Jumpers
The S5U13709P00C100 Evaluation Board includes the following 2-pin, 3-pin and 8-pin jumper blocks which are
used to control function and for power consumption measurement. For jumper locations on the evaluation board,
see Figure 3-2: "Configuration Jumper Location"
S5U13709P00C100 Evaluation Board
(Rev.1.1)
Table 3.2 Summary of Configuration Options
S1D13709
Pin
1 (ON)
CORECE
PLLCE
Figure 3.2 Configuration Jumper Location
Seiko Epson Corporation
Installation and Configuration
Configuration State
0 (OFF)
Normal use
Normal use
Not use
Not use
5