Chapter 3 Installation And Configuration; Cnf[2:0] Configuration - Epson S5U13L01P00C100 User Manual

Chapter 3 Installation and Configuration

The S5U13L01P00C100 evaluation board incorporates a DIP switch, jumpers, and 0 ohm resistors which allow it
to be used with a variety of different configurations.

3.1 CNF[2:0] Configuration

The S1D13L01 has 3 configuration inputs CNF[2:0], which are used to configure the S1D13L01 host interface type
through DIP switch SW1. Depending on the CNF[2:0] setting, some host interface pins will not be used. Those pins
should be terminated by SW2 and SW3.
S1D13L01 Direct 16-bit
Pin Name Mode 1
CNF[2:0] 000
CS# CS#
WR# WR#
RD# RD#
UB# UB#
LB# LB#
AB0 TE (JP108 2-3) TE (JP108 2-3) TE (JP108 2-3) TE (JP108 2-3)
AB1 AB1
AB[18:2] AB[18:2]
DB0 DB0
DB1 DB1
DB[7:2] DB[7:2]
DB8 DB8
DB[15:9] DB[15:9]
Note
1. For SW2~3, the setting must be Off if there is no suggestion in table.
2. For JP105~109, the setting must be 1-2 if there is no suggestion in table.
3. Low means internal pull-down for address bus active.
4. The SPI interface is not available when the S5U13L01P00C100 evaluation board is used with the
S5U13U00P00C100 USB adapter board.
S5U13L01P00C100 Evaluation Board
Rev. 1.3
Table 3-1: Host Interface Pin Mapping
Direct 16-bit Indirect 16-bit
Mode 2 Mode 1
001 010
CS# CS#
RDU# WR#
RDL# RD#
WRU# UB#
WRL# LB#
AB1 P/C#
AB[18:2] Low
DB0 DB0
DB1 DB1
DB[7:2] DB[7:2]
DB8 DB8
DB[15:9] DB[15:9]
Seiko Epson Corporation
Installation and Configuration
Indirect 16-bit
Direct 8-bit
Mode 2
011 100
CS# CS#
RDU# WR#
RDL# RD#
WRU# SW2-1=On
WRL# SW2-2=On
AB0
P/C# AB1
Low AB[18:2]
DB0 DB0
DB1 DB1
DB[7:2] DB[7:2]
DB8 TE (JP108 3-4)
DB[15:9] SW3-2~8=On
Indirect 8-bit SPI
101 111
CS# CS#
WR# SCK
RD# SW2-3=On
SW2-1=On SW2-1=On
SW2-2=On SW2-2=On
TE (JP108 2-3) TE (JP108 2-3)
P/C# Low
Low Low
DB0 SI
DB1 SO
DB[7:2] SW2-5~10=On
SW3-1=On SW3-1=On
SW3-2~8=On SW3-2~8=On
7