Definition And Terminology - SMC Networks EX600-WEN Operation Manual

1.1. Definition and terminology

Term
Administrator mode
A
B
Broken line detection
D
DHCP
Dummy Remote
E Export
F
Fieldbus
Full duplex
H
Half-duplex
I Import
I/O Configurator
(NFC version)
I/O Map
IP address
M MAC address
Manifold
Module
Monitor mode
N
NFC
Number of outputs
Administrator mode allows the user to configure the wireless units.
A broken wire to the input or output equipment has been detected by the diagnostic
function.
A protocol that automatically allocates information, necessary to be registered to use
the network, such as an IP address, to individual devices connected to the TCP/IP
network.
A Dummy Remote can be used to reserve a dummy area within the I/O map. A Wireless
Remote can then be registered to the dummy area at a later time, without having to
change the I/O map
Function to save the configured values of a wireless unit by exporting them to a PC.
Network protocol to establish digital communication between an automated industrial
system such as a measurement tool or manipulation tool and a PLC.
Communication system that can send and receive data at the same time
bi-directionally.
Communication method that can send and receive data reciprocally in bi-directional
communication.
Function to reconfigure a wireless unit by importing values stored on a PC.
Application used to directly set and monitor the wireless unit parameters via an NFC
reader/writer.
Memory area reserved for the I/O data and diagnostic information of the wireless system
A 32 bit digit sequence which is assigned to identify devices which are connected to the
network.
A unique number inherent to all devices connected to an Ethernet network.
Aggregate.
A Module consists of a Wireless Base or a Wireless Remote combined with I/O units
and a valve manifold.
Monitor mode allows the user to monitor the configuration of the wireless units but not
make setting changes.
Abbreviation of Near Field Communication. A Non-contact short distance wireless
communication used for configuration of the Wireless units
Number of points which can operate output equipment such as a valve, lamp or motor
starter.
-5-
Definition
No.EX※※-OMV0017-C