Introduction; Firmware Versions - Mircom TX3 Series Installation Manual

This manual provides information about the installation and operation of the
TX3 Elevator Restriction System, and must be read in its entirety before
beginning any installation work.
Installation must be performed by a qualified technician and must adhere to the
standards and special notices set by the local regulatory bodies.
Note:
For warranty and special notices information, see the Warranty and Special
Notices chapter on page 40.
Warning: The Telephone Access System assembly must be grounded by a
This manual explains
•
1.1

Firmware Versions

Note:
TX3 panels run either version 2 firmware or version 3 firmware, depending on
their hardware.
•
•
•
Elevator Restriction System Installation and Operation Manual
Version 1.2
LT-9940 Copyright 2018
Mircom periodically updates panel firmware and
Configurator Software to add features and correct any minor
inconsistencies. For information about the latest firmware or
software visit the Mircom website at www.mircom.com.
qualified electrician. An improperly grounded unit can result
in equipment malfunction and electrical shock.
Elevator Restriction Unit Installation and Operation
For instructions on upgrading firmware see LT-995 TX3
Touch Screen Administrators Guide.
If your panels run version 2 firmware, you must upgrade to version 2.4.x
or higher in order to use the latest elevator restriction features.
If your panels run version 3 firmware, you must upgrade to version 3.4.x
or higher in order to use the latest elevator restriction features.
If you do not upgrade your panels to version 2.4.x or 3.4.x, you can still use
elevator restriction but you cannot access the new features.
1

Introduction

5