Fuji Xerox Versant 3100 Press Printer Unit Manual page 30

9.
Push the Tray into the machine.
The [Tray Stock Properties] window appears on the Stock Library Manager.
Important
Note
10.
Change the Tray settings.
11.
To remove the Postcard Kit from the Tray, loosen the screw completely and then
remove the Kit.
12.
Store the Kit in place by inserting it from the left side
of the Tray (
Special Media Setting
 Transparency
Loading side: Load sheets with the printed side facing up.
 Hole punched paper
Orientation: Place the holes of paper on the right side when you face the front side of printer.
 Precut tab
Orientation: Place the tabs of paper on the left side when you face the front side of printer.
 Envelope
Loading side: Load sheets with the printed side facing up.
Direction with the flap open: Place the flap of Envelope on the left side when you face the front side of
Direction with the flap closed: Place the flap of Envelope on the right or near side when you face the front
Note If envelopes are loaded with the flaps unfolded, the size will not be automatically detected as standard

size.
Fold the flaps when loading self-seal envelopes.

If you place the flap of envelope closed on this side, a failure in printing might occur on the rear edge of

papers depending on the arranged images.
Improving Paper Feed Precision
If print skew (misregistration of print) occurs on properly loaded paper, the problem can be solved by
switching the paper feed precision.
On other than plain paper with 220 g/m
because papers may not normally be fed. Also, this function has no effect when you use the Postcard Kit.
Important
30
Printer Unit Manual
In the event power is disconnected while the Tray's bottom plate is rising, the plate may not move
up when the power is recovered. In this case, pull out the Tray, make sure the plate is lowered, and
then push the Tray into the machine slowly and firmly.
When paper sheets are loaded or fed, the Tray makes a sound of supplying air. This is caused by the
Air Assist function that supplies air to coated or heavy weight paper, and not an abnormal noise.
1
) and tightening the screw (
printer.
side of printer.
2
).
2
or less, switching the paper feed precision may cause the paper jam