Fuji Xerox Versant 3100 Press Printer Unit Manual page 35

Symptom
Unable to print
Troubles with the Trays
Refer "2.3 Loading Paper" (p.25)
Symptom
Unable to insert or Did you open a cover or turn the
remove the Tray power switch off during printing?
Indicated paper level Is there extra paper or any object
is wrong placed in a space in the Tray?
Tray bottom plate Is paper loaded correctly?
does not move up
(High Capacity
Trays)
Is any paper sheet stuck at the
exit of the Tray?
Was power supply disconnected
while the bottom plate was rising?
Is there extra paper or any object
placed in a space in the Tray?
Is the paper curled?
Is the loaded paper different from
what is set on the Stock Library?
Cause
Is the message "Machine Cooling in
Progress" displayed on the touch
screen?
Is any of below happening?
The power was left OFF for a long

time.
A job was sent right after the printer

returned from the Sleep mode.
A job with large volume was sent.

Does the loaded paper correspond
with the stock set with Stock Library
Manager?
Cause
The printer is in cooling mode. Please wait.
"1.2.1 Services Home" in the User
Refer
Interface Manual.
It may take time to start printing as image
quality adjustment is in progress.
Load the corresponding paper and print the
job again.
Stock Library Manager Manual
Refer
Remedy
Do not forcibly insert or remove the Tray. Turn the power
switch off. In a few seconds, switch on the power.
When the printer is ready to receive data, insert or
remove the Tray.
Placing extra paper or anything in the space may cause
the printer to recognize incorrect paper size or paper
level or to malfunction. Make sure nothing is placed in
the space.
First remove all the paper from the Tray, and then
reload it correctly. Slide the long-side and short-side
paper guides to just touch the edges of the paper. Push
the Tray into the machine slowly and firmly.
Remove jammed papers and push the Tray into the
machine slowly and firmly.
If yes, the bottom plate may fail to move up when the
printer is powered on again.
In this case, pull out the Tray, make sure the plate is
lowered, and then push the Tray into the machine
slowly and firmly.
Placing extra paper or anything in the space may cause
the printer to recognize incorrect paper size or paper
level or to malfunction. Make sure nothing is placed in
the space.
Turn over or flatten the curled paper, or replace with
uncurled paper.
Do not use 12 mm or more curled paper.
Change the stock settings to match the loaded paper.
Load the same paper set on the Stock Library.
Chapter 3 Problem Solving
Remedy
35