Installation Cable - Seagull Models GISPY MOTH Assembly Manual

GISPY MOTH.
M3x20mm.

INSTALLATION CABLE.

1)Prepare one end of the cable by attaching
a cable end using a copper crimp. Thread a
nut, then a clevis, on the cable end as shown.
Prepare only one end of each cable at this
time.
Crimp
M3 clevis
2)Attach the clevis to the brass tab next to
the rear interplane strut on the upper-lower
wing.Slide a copper crimp on the cable. Pass
the cable through the brass tab on the upper
wing, the back through the copper crimp.
24
Metal Cable.
working from the ends that have been crimped
to the ends that have not. There should be light
tension on all the cables, but not enough to
change the position of the wing. Once the
cables have been tensioned, begin by securing
the crimps where the cables pass through the
tabs near the fuselage. Then secure the crimps
at the cable ends. Once tensioned, use side
cutters to trim the excess cable.
Instruction Manual.
3)Begin placing tension on the wires,