Getting Started; Initial Setup - Analog Devices AD9166-FMC-EBZ User Manual

AD9166-FMC-EBZ

GETTING STARTED

Software installation includes an updated version of the
DPGDownloader software and the necessary files for the
AD9166-FMC-EBZ evaluation board, including the schematic,
board layout, and data sheet. Download the DPGDownloader
software online from the DAC Software
wiki.analog.com/resources/eval/dpg/dacsoftwaresuite.
Also install the ACE software to configure the device.
the software that is used to load the registers in the AD9166.
The ACE software enables full access to the
map and has several views and features that simplify its use.
Many of the ACE software features are detailed in the ACE User
Guide section.
Download this software online from the
The ACE software package includes the required plugins for the
AD9166-FMC-EBZ evaluation board.
User Guide
Suite, at
ACE
AD9166 register
ACE software page.

INITIAL SETUP

Complete the following initial steps to get started with the
evaluation of the device:
1. Install the DPGDownloader software on the PC. Analog
Devices, Inc., recommends verifying the basic setup before
making any modifications to the evaluation board.
is
2. Connect the PC to the
connector.
3. Connect the evaluation board to the
the FMC connector.
4. Switch the power connector on the
up both the evaluation board and the ADS7-V2EBZ.
Several different configurations and scenarios are explained in
this user guide with step by step instructions. Choose the
configuration that meets the requirements. A summary of the
ACE user guide is provided in the ACE User Guide section.
Rev. 0 | Page 7 of 23
UG-1698
ADS7-V2EBZ using the USB
ADS7-V2EBZ
ADS7-V2EBZ to power
using