Setting Up Your Wireless Network; Configuring The Dip Switches - Banner SureCross DX80 FlexPower Manual

SureCross DX80 FlexPower Thermocouple Node

Setting Up Your Wireless Network

To set up and install your wireless network, follow these steps:
1. Configure the DIP switches of all devices.
2. Connect the sensors to the SureCross devices.
3. Apply power to all devices.
4. Form the wireless network. For binding instructions, refer to the product manual.
5. Observe the LED behavior to verify the devices are communicating with each other.
6. Conduct a site survey between the Gateway and Nodes. For site survey instructions, refer to the product manual.
7. Install your wireless sensor network components. For installation instructions, refer to the product manual.
For additional information, including installation and setup, weatherproofing, device menu maps, troubleshooting, and a list of accesso-
ries, refer to one of the following product manuals.
• SureCross Quick Start Guide: Banner part number
• SureCross Wireless I/O Network Manual:
• Web Configurator Manual (used with "Pro" and DX83 models):
• Host Configuration Manual

Configuring the DIP Switches

integrated into the housing, remove the battery for at least one minute. DIP switch changes will not be recognized if power isn't cycled to
the device.
Accessing the Internal DIP Switches
To access the internal DIP switches, follow these steps:
1. Unscrew the four screws that mount the cover to the bottom housing.
2. Remove the cover from the housing without damaging the ribbon cable or the pins the cable plugs into.
3. Gently unplug the ribbon cable from the board mounted into the bottom housing. For integrated battery models (no ribbon cable) and
Class I, Division 2 certified devices (ribbon cable is glued down), skip this step.
4. Remove the black cover plate from the bottom of the device's cover.
The DIP switches are located behind the rotary dials.
After making the necessary changes to the DIP switches, place the black cover plate back into position and gently push into place. Plug
the ribbon cable in after verifying that the blocked hole lines up with the missing pin. Mount the cover back onto the housing.
DIP Switch Settings
Device Settings
Rotary switch address mode
Extended address mode
Temp °Fahrenheit
Temp °Celsius
High resolution (0.1 degree)**
P/N 131297 rev. I
128185
132607
132114
Before making any changes to the DIP switch positions, disconnect the power. For devices with batteries
1
OFF*
ON
www.bannerengineering.com - tel: 763-544-3164
134421
Switches
2 3 4
OFF*
ON
OFF*
5 6 7 8
3