Banner SureCross DX80 FlexPower Manual page 6

Terminal Block (IP20)
For the DX8x...C models, PWR in the wiring diagram refers to V+ on the wiring board and GND in the wiring diagram refers to V- on the
wiring board.
DI1
DI2
A1+
A1-
A2+
A2-
V+
V-
V-
Ax+ and Ax-. Analog IN x. Analog inputs for devices requir-
ing more than one connection, such as thermocouples or
RTDs. When there is no Ax-, use Ax+ as an analog input.
B+. 3.6 to 5.5V dc (for battery powered models only).
Wiring Diagrams for Discrete Inputs
Connecting dc power to the communication pins will cause permanent damage. For the DX8x...C models, PWR in the wiring diagram
refers to V+ on the wiring board and GND in the wiring diagram refers to V- on the wiring board.
Discrete Input Wiring for PNP Sensors
PWR
10-30V dc
DIx
Wiring Diagrams for Discrete Outputs
Connecting dc power to the communication pins will cause permanent damage. For the DX8x...C models, PWR in the wiring diagram
refers to V+ on the wiring board and GND in the wiring diagram refers to V- on the wiring board.
Discrete Output Wiring (NPN or NMOS)
PWR
DOx
Load
GND
Wiring Diagram for Thermocouple Inputs
Ax+
+
TC
− Ax−
6
DIx. Discrete IN x.
DOx. Discrete OUT x.
DO1
GND. Ground/dc common connection.
DO2
PWR. Power, 10 to 30V dc power connection.
A3+
A3-
RX/-. Serial comms line
A4+
TX/+. Serial comms line
A4-
Tx
V+. Power, 10 to 30V dc power connection.
Rx
V-. Ground/dc common connection.
B+
10-30V dc
dc common
Thermocouple: When wiring the thermocouple, x is the same number. For ex-
ample, a thermocouple is wired to A1+ and A1-.
www.bannerengineering.com - tel: 763-544-3164
SureCross DX80 FlexPower Thermocouple Node
Discrete Input Wiring for NPN Sensors
DIx
GND
dc common
P/N 131297 rev. I