7.12 Write of Settings
This function writes the control settings to the parent terminal of control unit.
*This function is available when the parent terminal is in the STOP status of control operation.
If you attempt to execute it in the RUN status, a message will appear to ask whether to execute after the status is changed
to STOP.
(1)
Connect the computer and the parent terminal with a LAN cable.
*Set the computer's IP address in order to be in the same network.
(2)
Enter the password of the parent terminal.
For the password, refer to
(3)
Click the Write settings button to write the settings.
(4)
After the write has been completed, the following message appears.
Click the OK button to close the message.
If the write execution fails, refer to
7.13 Change of RUN/STOP
This function changes the control operation status of the parent terminal of control unit.
To execute the change, the parent terminal must be connected to the computer with a LAN cable.
(1)
Connect the computer and the parent terminal with a LAN cable.
*Set the computer's IP address in order to be in the same network.
(2)
Enter the password of the parent terminal.
For the password, refer to
10.3 Change of Password.
11.3 Q&A to identify the source. After eliminating it, execute the write again.
10.3 Change of Password.
104