Connecting with Control Unit Engineering Tool
This subsection describes how to connect the control unit with Control Unit Engineering Tool.
The following operation illustrates an example of control unit's IP address with the default settings (IP address: 192.168.3.11,
Subnet mask: 255.255.255.0).
(1)
Connect the computer where Control Unit Engineering Tool is installed to the control unit with a LAN cable.
Change the computer's IP address so as to be in the same network with the control unit.
(2)
Click the Start button, select Windows system tool, and then open Control panel.
(3)
Select Network and internet and then open View network status and tasks.
Start button
24