Mitsubishi Electric EMU4-CNT-MB User Manual page 96

(5) Set the ON/OFF time of contact output in the day for each contact output.
Item
Time Set the time to switch the ON/OFF contact output.
It is possible to set by the minute.
After selecting an hour or minute, enter a number or click the ▲ or ▼ button to set.
Including 0:00 of the first field, a maximum of 24 times can be set.
Default: 0:00
Control status Select ON or OFF for contact output from the pull-down menu.
(valid/invalid) Default: Non setting (Blank)
*1: To the first field (0:00) of the control status, be sure to set other than blank.
*2: It is impossible to set the same time to other field repeatedly.
*3: Except for the first field (0:00), be sure to set the control status (ON/OFF) to any fields where the time is set.
Useful function: Copy of pattern
If you want to set the same output state pattern as other one, use the copy function to copy the output state
pattern.
*The registered pattern can be copied. If in the process of editing a pattern, first register and then copy it.
*It is impossible to copy any output state patterns with different day pattern numbers.
(1) Select a terminal ID (①) and DY (②) of the copy source from the pull-
down menu.
(2) Select a DY (③) of the copy destination from the pull-down menu.
(3) Click the Copy button to copy the output state pattern of the selected
① and ② to the DY of the selected ③.
Details
95
Control is valid/invalid.
Time
①
③
②