Mitsubishi Electric EMU4-CNT-MB User Manual page 39

Manually Operating the Contact Output/Analog Output
Operation of Control unit
Connect the parent terminal of control unit
and the computer with a LAN cable.
When the output state of contact/analog
output is changed, the control operation
state of the unit will automatically change to
STOP. At this time, any output states other
than the changed output are as follows.
Control method
Interlocking control
Compressor control
Schedule control
Change the control operation state of the control unit to RUN.
It can be changed both from the unit and from the software.
Control unit operation
Set the STOP/RUN switch of the unit to RUN.
Start
Output state
Retention
All OFF
Retention
Execute it from either of them.
End
38
Operation of Control Unit Engineering Tool
Change the output state of contact/analog
output.
Refer to 9.2 Manual Control of
output.
Setting the control operation state to RUN starts the
control. Execute it in good condition to operate.
Software operation
Change the control operation state of the unit.
Refer to 7.13 Change of RUN/STOP.