Replacing Hydrostatic Transmission Wire; Removal Of Hyrostatic Transmission Wire - Husqvarna Rider 18 ProFlex Workshop Manual

Replacing hydrostatic transmission wire

Removal of hydrostatic transmission wire
All the photos show the Rider 18 ProFlex. The
procedure is the same for the Rider 20 ProFlex, on
which the hydrostatic wire is attached to the left-
hand side of the rear frame.
1
Remove the frame plate by undoing the screws
(two on each side).
2
Unscrew the front end of the hydrostatic transmis-
sion wire and remove the wire clip.
3
Unbolt the front wire-retaining clip from inside the
tunnel.
4
Remove the transmission cover.
5
Follow the hydrostatic transmission wire back to the
transmission and cut through the cable tie around
the cables. Unscrew the clip that holds the trans-
mission wire.
6
Remove the wire clip from the rear ball joint.
Reparation instructions
35
English –