Led Indicator Of The Charging Station For Boundary Wire Installation; Symptoms - Husqvarna AUTOMOWER 320 NERA Operator's Manual

7.4 LED indicator of the charging station for boundary wire installation

The LED indicator of the charging station is green when the installation is correct. If the LED indicator of the charging
station is not green, follow the troubleshooting table below.
Speak to your local Husqvarna representative or go to www.husqvarna.com for more information.
LED indicator
Constant green
Flashes green
Flashes blue
Flashes red
Constant red

7.5 Symptoms

If the product does not operate as usual, follow the symptoms table below. Speak to your Husqvarna customer
service if you cannot find the cause for the fault.
Symptoms
The product has diffi-
culty docking.
The product operates
at the wrong time
The product vibrates.
2071 - 001 - 29.03.2023
Cause
The signals of the charging station are good.
The signals of the charging station are good
ECO mode is enabled.
and
The boundary wire is not connected to the
charging station.
The boundary wire is damaged.
Interference in the antenna of the charging
station.
Error in the circuit board or incorrect power
supply in the charging station.
Cause
The guide wire is not put straight in a line
and correct distance from the charging sta-
tion.
The guide wire is not put in the slot in the
charging station plate.
The charging station is not on a level sur-
face.
The time or the date in the product is not
correct.
The start and stop times for operating are
incorrect.
The cutting system is not in balance because
of damaged blades.
The cutting system is not in balance because
of too many blades in the same position.
Different thickness of blades are installed on
the product.
Action
No action is necessary.
No action is necessary.
Connect the boundary wire to the charging
station.
Replace the damaged section of the boun-
dary wire with new boundary wire.
Speak to your local Husqvarna representa-
tive.
The error must be corrected by an authorized
service technician. Speak to your local Husq-
varna representative.
Action
Do a check of the installation of the charging
To install the charging sta-
station. Refer to
tion on page 17
Make sure that the guide wire is put straight
in a line and put in the slot in the charging
To install the guide
station plate. Refer to
wire on page 18 .
Put the charging station on a level surface.
To examine where to put the charg-
Refer to
ing station on page 11 .
Set the time or date. Refer to
page 23 .
Schedule settings. Refer to
Change the
Schedule on page 20 .
Examine the blades and screws and replace
them if necessary. Refer to
the blades on page 29 .
Do a check that only one blade is attached at
each screw.
Do a check if the blades are of different thick-
ness and replace if necessary.
Time & date on
Replacement of
Troubleshooting - 37