13
14
1
7
Remove the lower bearing's circlip (9) and take the
bearing (10) out downwards.
8
Take the steering axle out (5) downwards.
9
To assemble the steering axle, the reverse order is
applied. For assembly purposes, the two steering
wheel rod carriers (3), are tightened with moment
(5–10 Nm).
Removal/installation of wire wheel
1
Detach the steering wires' rear attachment (1) .
2
Remove the screw (12) and detach the wire wheel
(11).
8
11
12
3
Remove the bearing's circlip (13) and knock out the
bearing (14).
4
To install the wire wheel, the reverse order is
applied.
After installation, check the wire tension (see page
17).
For Rider 1030 Bioclip and Rider 1200, there is a
complete set (attachment, wire wheel, bushing,
bearing) to assemble, article no. 506 50 09-01. For
Rider 850 and Rider 970, the parts are ordered
separately.
Reparation instructions
7
2
9
2
4
3
5
6
10
19
English –